1/2 Pusher Seals for Steel Strapping 5000/Case cohesive bubble wrap rolls 1 with light transmission not

1 with light transmission not exceeding 10% at any wavelength from 290nm to 450nm

Instantly folds into place

computer parts medicine or film

No dispenser needed for this flat back tape - easy to tear by hand and apply

1/2 Pusher Seals for Steel Strapping 5000/Case cohesive bubble wrap rolls 1 with light transmission notFor use with steel strap, our pusher seals are galvanized for rust prevention. (See also Open Seals). Simple Instructions: First slide a pusher seal (listed below) on your steel strap, manually wrap the steel strap around the load feeding the end of your strap through the seal as well, tighten the top layer steel strap in the seal with our pusher tensioner, next crimp the seal with a single notch sealer, and finally cut the excess strap with our steel